Type what you are searching for:

Shop

Meoded Paint & Plaster / Stain Block Elite Sealer
stain_block_elite

Stain Block Elite Sealer

$102.20

Clear
SKU: N/A Category:

Description

Description:

Stain Block Elite: Invisible Penetrating Stain Blocking Sealer

LIMITATIONS: Will not resist moisture where hydrostatic pressure is active. Do not use as pre-grout sealer. Once installed this product is not removable.

IMPORTANT NOTE: Before use on a job, thoroughly test this product on an inconspicuous area to assure performance and appearance. Use only in well ventilated areas. Immediately remove pools or puddles where over application has occurred.

Application

Surface Preparation:

All surfaces to be treated must be clean and free from dirt, moss, mildew, laitance, efflorescence, and any other contaminate that may interfere with the penetration or reaction of Stain Block Elite to the applied surface. Remove all dirt, oil, paint or sealers with appropriate cleaner, chemical stripper or abrasive blasting. If muriatic acid has been used the surface must be flushed with clean water and neutralized with a pH neutralizer. After cleaning, allow surface to dry 24 hours prior to sealer application. Allow new concrete to cure for at least 28 days before application of sealer. Protect greenery from over spray.

Thinning:

Not required. Use as is.

Application:

Stain Block Elite can be applied with a brush, roller, or most types of low pressure, hand pump, spray equipment. Do not aerosolize (vapor like mist) with airless spray equipment. On dense surfaces one coat is all that is required to seal and protect the surface. If a second coat is necessary due to extreme porosity, apply immediately after the first coat has soaked in. For small areas, a pump-up garden sprayer is convenient. For large commercial installations a large capacity pump spray system is recommended. Do not apply Stain Block Elite during wet weather or when surface temperature exceeds 80°F. Application to a damp surface or incompletely cured concrete may cause a hazy appearance or loss of adhesion. Air and surface temperature should be between 50° and 80°F for 24 hours following application.

Brush: Synthetic bristle brush

Roller: 3/8″ nap roller

Low pressure pump sprayer

Coverage

Coverage:

200 – 1000 sq.ft./gal

Theoretical is 200 to 1000 sq. ft./gal. depending on texture and porosity of the surface to be painted and method of application. For exact coverage rates, a measured quantity to proper application over a known area will provide a square foot coverage rate for a specific job.

Process

Dry Schedule:

Dry Time: 30 mins to 3 hrs

Rainproof: 12 hrs

Cure Time: 48-72 hrs

Water Pepetration Test:

Drop a small amount of water on the sealed surface. If water penetration occurs or if water does not bead up on the surface, the application of additional sealer is required.

Maintenance:

Minimal maintenance is required except for sweeping the surface of dirt and wiping up spills soon after they occur. Perform “Water Test” once a year. If test fails, reapply Stain Block Elite.

Clean Up:

Soap and water

Remove:

Not removable

Reviews

There are no reviews yet.

Be the first to review “Stain Block Elite Sealer”

Your email address will not be published. Required fields are marked *