Sapphire Metallic Paint – Sahara Effect

Application

Surface Preparation:

All surfaces must be clean and free of dust, dirt, oils and grease. Make sure the surface is sound and free of loose and flaking paint. Priming the substrate is highly recommended, and do not paint over shiny, smooth surfaces, such as plastic or glossy oil-based paints, unless prepared with the right primer.

Sahara Lines Application Method:

Base coat: It is recommended to roll a Sapphire Metallic base coat or a matching color eggshell paint. For full dry time wait 12 hours.
Second Coat: Add 2.5 lbs. of glass beads to 1 gallon of Sapphire Metallic paint and stir well. Use a 4” brush to coat the surface creating either horizontal, vertical or diagonal lines. Immediately after, take a clean brush to smoothen the surface and straighten the lines.

Sahara Fabric Application Method:

The fabric technique uses a rigato tool to design the Sahara fabric look with horizontal, vertical, or diagonal lines.
First coat: Add 2.5 lbs. of glass beads to 1 gallon of Sapphire Metallic paint and stir well. Use a 4” brush to coat the surface creating horizontal lines. Immediately after, use a rigato tool to smoothen the surface and straighten the lines. Once the lines have been straightened, take a clean brush to smoothen the lines once again. For full dry time wait 12 hours.
Second Coat: Use a 4” brush to coat the surface creating vertical lines. Immediately after, use a rigato tool to smoothen the surface and straighten the lines. Once the lines have been straightened, take a clean 4” brush to smoothen the lines once again.

Exterior Application:

It is recommended to protect Sapphire Metallic with Meoded Clear Satin or Clear Gloss for exterior applications. Two coats will usually provide adequate protection, while three coats are recommended for high traffic areas.